paul bishop
  • Male
  • Melb Vic
  • Australia
Share
  • Blog Posts
  • Discussions (27)
  • Events
  • Groups
  • Photos
  • Photo Albums

Paul bishop's Friends

  • Greg_

paul bishop's Discussions

Pinasco clutch gear

Started this discussion. Last reply by paul bishop Aug 9. 2 Replies

Got a pinasco clutch drive plate/gear with 24 teeth (std is 23) to make gearing a bit higher. Fitted it on to my P200E by just removing clutch (no case split). Has made a bit of a difference in the…Continue

Increasing gear ratio

Started this discussion. Last reply by paul bishop Oct 14. 4 Replies

Looking to get a few lower rpm on highway travel. Anybody put a 100/90/10 tyre on the back (did it fit) and another option is to use 24 tooth clutch drive gear, to replace original 23 t one. I think…Continue

PX voltage regulator wiring

Started this discussion. Last reply by paul bishop Dec 21, 2018. 4 Replies

Can anybody advise the wiring for GGB+c regulator on a PX. Various diagrams available online show conflicts for the G terminals. One is unregulated AC input, and the other is regulated 12V AC out. B+…Continue

Tags: Regulator

P200E Gearbox

Started this discussion. Last reply by paul bishop Jul 7, 2018. 2 Replies

Have a p200e and am doing gearbox job. Couple of questions, when the gears are fitted to shaft, should the slots for cruciform all be aligned, or is there no difference? Next question, are the gears…Continue

 

paul bishop's Page

Latest Activity

paul bishop replied to paul bishop's discussion Increasing gear ratio
"Yes thanks John. That was the route i went, but with Pinasco part. Worked fine with marginal difference. There is now a slight gear whine on closed throttle over-run is only thing i noticed. Highway ride revs a bit lower, and uphill need to change…"
Oct 14

Profile Information

Vespa Model(s) you own
P200E

Comment Wall (2 comments)

You need to be a Registered User of Vespa Club of Melbourne to add comments!

Join Vespa Club of Melbourne

At 20:54 on May 3, 2015,
MEMBER
Julie Pond
said…

Hi Paul

Welcome to the site...hope we get to meet you sometime soon.

Cheers Julie

At 19:49 on May 3, 2015,
MEMBER
Greg_
said…

Hi Paul and welcome to the website. Come along to next Sunday's breakfast and talk Vespa.

 
 
 

Registered Users

© 2019   Vespa Club of Melbourne Incorporated in Victoria A005069N   Powered by

Badges  |  Report an Issue  |  Terms of Service