paul bishop's Discussions (31)

Discussions Replied To (18) Replies Latest Activity

"Yep sounds like a good plan. Thanks Rolf."

paul bishop replied Feb 14 to Carburettor upgrade

4 Feb 14
Reply by paul bishop

"Thank you Rolf. I have put on a pinasco 24t clutch drive which does drop a few rpm a…"

paul bishop replied Feb 14 to Carburettor upgrade

4 Feb 14
Reply by paul bishop

"Yes thanks John. That was the route i went, but with Pinasco part. Worked fine with…"

paul bishop replied Oct 14, 2019 to Increasing gear ratio

4 Oct 14, 2019
Reply by paul bishop

"Great thanks Darren. That's kind of what I figured, and wasn't sure about the wear f…"

paul bishop replied Aug 9, 2019 to Pinasco clutch gear

2 Aug 9, 2019
Reply by paul bishop

"Thanks Rolf. There is a clutch drive gear available with 12 teeth rather than standa…"

paul bishop replied Jul 12, 2019 to Increasing gear ratio

4 Oct 14, 2019
Reply by paul bishop

"Thanks Rolf."

paul bishop replied Dec 21, 2018 to PX voltage regulator wiring

4 Dec 21, 2018
Reply by paul bishop

"Thanks Bob. I suspect you might be right, and was my thoughts also. The B+ is also s…"

paul bishop replied Dec 19, 2018 to PX voltage regulator wiring

4 Dec 21, 2018
Reply by paul bishop

"Hi David. Thank you for the info. The links were very helpful. Not planning to chang…"

paul bishop replied Jul 7, 2018 to P200E Gearbox

2 Jul 7, 2018
Reply by paul bishop

"Great, thanks David. That was my plan to go with the GPS option. My existing filter…"

paul bishop replied Feb 20, 2017 to Air filter drilling P200E

4 Feb 20, 2017
Reply by paul bishop

"Hi Greg. No it's a P200E VSX1T and carb is dell orto Si 24/24"

paul bishop replied Feb 20, 2017 to Air filter drilling P200E

4 Feb 20, 2017
Reply by paul bishop

RSS

Registered Users

© 2020   Vespa Club of Melbourne Incorporated in Victoria A005069N   Powered by

Badges  |  Report an Issue  |  Terms of Service